Vantage Touch keypad Controller User Manual Guide

VV-RF100-CAR1  Touch Keypad Door Controller

WIRING DIAGRAM:-

RED--------- DC +12V

BLACK--------- GND

BROWN--------- NO CONNECTION

GREY--------- NO CONNECTION

ORANGE--------- BUTTON

PINK--------- NO CONNECTION

GREEN--------- NORMAL CLOSE

PURPLE--------- COM

BLUE--------- NORMAL OPEN

YELLOW--------- DOOR BELL

WHITE --------- GND

IT CAN BE STORE UP TO 1000 RFID CARD OR PINS

Master Code: 1234

Adding the User Pins:-

Enter the Setting Mode by Pressing 1234 1234

Now press 02 (A Short tone will be heard and mode indicator will stop flashing) the enter the location Code from 000 to 999 (Like Location 1 so i use 001 then location 2 i use 002) Now enter the New User  PIN for Access like 4444 or 5555(must be same length as master code) Now to save all the setting press # for Save and  # for Exit ( 2 Times)

Adding the User CARD:-

Enter the Setting Mode by Pressing 1234 1234

Now press 01 (A Short tone will be heard and mode indicator will stop flashing) the enter the location slot from 000 to 999 (Like if you want to batch enter 50 cards press 050 then show all cards one by one it will allocate each card next slot from 1 to 50) Now Show Cards one by one. You can use same setting to add single card by choosing Slot 001 for 1 card. After that you can choose 002 for second Card to register after that to save all the setting press # for Save and  # for Exit ( 2 Times)

Set the Unlocking Time:-

Enter the Setting Mode by Pressing 1234 1234

Now press *1 (A Short tone will be heard and mode indicator will stop flashing) the enter the number from 00 to 99 (05 = 5 Seconds and 10 = 10 Seconds) Now press # for Save and  # for Exit ( 2 Times)

 

Restore to Factory Settings

Press *8 then Press 99 (a Short Tone will be buzz)

Press # to exit

Note: All Cards and PINS will be removed and Default Master Code will be set to 1234

Subscribe Us on YouTube: CCTV Networking Technical Support